Dinette to bed

[Outback KR]

I'm in a keystone Outback 2016 could someone let me know how to change it over to a bed? Seats on both sides and one poll. Or does it? Thank you

 

[Texas Steve]

You should be able to lift the table top off of the pole and then remove the pole from the floor mount. The table top is then set on wooden rails at the bench seats. Rearrange the cushions to make it into a bed. Store the pole until it is time to make it into a table again. Hope this helps.

 

[skids-JAY]

Check it the security of the construction. In my Bullet, there was a strip of wood on each side that is supposed to support the table when it is a bed. As I remember, mine was attached with staples and it appeared as if one side was starting to pull away.. I installed screws to supplement construction.

 

[JRTJH]

Check it the security of the construction. In my Bullet, there was a strip of wood on each side that is supposed to support the table when it is a bed. As I remember, mine was attached with staples and it appeared as if one side was starting to pull away.. I installed screws to supplement construction.

Not only are the side supports barely attached to the dinette seats in many trailers, but most of the table tops are MDF that's either half inch with a 1" flange or 5/8"... Unfortunately, when the bed is made, the center of the table top is "exactly where you have to sit" to get into bed. So, there is a real, REAL good chance that someone heavier than a 10 year old, who sits on the table top to then lay down might not only detach the stapled supports, but also crack or even fold in half the MDF table top....