City water connection

[Gayleatokcorral]

The city water connection on the rear of my 2017 Keystone laredo is worn. Can not find replacement. Part is plastic, one side screws into rv, other garden hose.
Any suggestions on where to find?

 

[wiredgeorge]

The city water connection on the rear of my 2017 Keystone laredo is worn. Can not find replacement. Part is plastic, one side screws into rv, other garden hose.
Any suggestions on where to find?

Do you know how to post an image? That would make all the difference when trying to answer your question.

 

[chuckster57]

Like this?

https://www.amazon.com/Lead-free-Ba...hvlocphy=&hvtargid=pla-4584070155868813&psc=1

 

[wiredgeorge]

Chuck, the reason I suggested a picture is that mine looks something like this:
https://www.amazon.com/Valterra-Whi...=rv+city+water+and+water+tank+,aps,460&sr=8-6

 

[chuckster57]

Odds are it’s one or the other.

 

[sourdough]

Odds are it’s one or the other.

OPs description sounds like a regular water inlet of which several brands are available on Amazon as you guys posted.

 

[wiredgeorge]

OPs description sounds like a regular water inlet of which several brands are available on Amazon as you guys posted.

I think that is kind of obvious to more experienced campers and hence the request for a picture.

 

[JRTJH]

If you look at the photo in the link that George posted, the back of the entire assembly, there is a "C Clip" that locks the actual city water backflow valve to the plastic housing. That part is available in black or white, manufactured by JR Products and sold on Amazon.

WHITE: https://www.amazon.com/JR-Products-...8&psc=1&mcid=f076e88fabd33f41925576037ff13256
Or: https://www.bonanza.com/listings/JR...0RdLmk0rbDLo6gE48BhCVw1N1UauIYrAaAjHOEALw_wcB

For the black valve, right now it looks like Amazon is out of stock, but you can buy the "round assembly" and pull the C clip to remove the backflow valve and then install that in your existing housing.

BLACK: https://www.amazon.com/JR-Products-...B00KNB6EUG/ref=psdc_10806173011_t2_B082FZ28GQ

All you need to do is take the city water connection assembly off the trailer sidewall, pull that C Clip, remove the old backflow valve, install the new one, reinstall the C clip and reinstall the assembly back on the trailer sidewall. Be sure to use new butyl putty tape to seal against potential water leaking when it rains.

The backflow valve is the same in the circular city water connection assembly and in the larger gravity fill/city water connection assembly.

Here's a photo of the back side showing the C Clip. You MIGHT have enough clearance to remove the C clip without removing the whole assembly, but I've always had to take it off the trailer sidewall to have enough space to work.