08 fuzion landing gear issue

[08fuzion]

I have a 08 fuzion 393 and when I try to unhook from truck landing gear ratchets, dealer sent two techs out to look at and now I have three sets of motor/gear drives all with same problem, went to a buddy's house and his raises/lowers with no problem. Has anybody experienced this issue before and what was the resolution? Thanks for the advice

 

[Randy68]

Do you have single motor setup or a dual motor set up?

 

[gman1966347]

Two things...the miter gears will wear of lacking in grease application. But in my case that would have been too easy. It is most likely the inside acme screw and nut. They are un-serviceable! Mine were on a 2009 raptor 299mp.The right hand side was easy.Was able to work thru the storage compartment. The left side a real pain in the ***! Had to remove the propane enclosure to replace it. But after that they worked fine. Then a week later traded it in on a 2013 montana 3150rl...LOVE IT!!! By your parts thru amazon. Way cheaper. Good luck buddy!