slide

When my slide won't go out, can I still use propane heat via Icommand? There is a wall vent, two floor vents under the slide that won't move and a floor vent in the bedroom. With the two vents covered by the slide, can I still get heat in the RV? It is getting a little cold and would like to...

We have a 2022 Cedar Creek Champagne 38EL 5th wheel trailer. Shortly after we purchased it, there was heavy rain and we took water into the bedroom from the area near the lower-rear corner of the bedroom slide. This was covered under warranty and the tech said that one of the seals was...

Greetings, 2024 Travato 59K. I have a rattle under the trim on the slider window. Before I start yanking and prying (and damaging....), does anyone know how to remove the plastic trim around the slider window so that I can fix the rattle underneath? I can't see how it is attached. Thanks!

This is my first post, but I have gotten some good information by reading this forum in the past. I hope I can get some input into an issue I am having. I have a 2023 Sprinter 32BH that has 3 slides. Today, I was trying to put in the slides and the Main slide would not respond. After a few...

2017 Winnebago Tour slides keep saying engage brake but brake is engaged. Now our brakes show light on dash even when not engaged. We replaced brake controller and one brake switch not sure if other needs replaced

Living in a 32 foot travel trailer, has two slides, question Is do i need to support the slides

I just purchased a 1990 challenger... looks like it's been in a time capsule! No battery so I'm trying to manually open the slide outs...I located the mechanism on the back side of the motor, have proper tool and screw gun.... tried right and left but no action????

Hello, I'm looking for a successful way to access the rear slide motors. I'm getting a trouble code saying either motor or motor wiring is at fault. Is this easily accessible or is there possibly a trick to access the motor? The slide is currently in. Thanks,

Two questions: I am convinced I have a bad motor on the main slide and need to take it out and order a replacement. How do I get the motor out. From the threads I’ve read people referred to removing a rubber boot. Is this the entire seal around the sides of the slide. Anyway, if someone could...

The 2021 Keystone Montana High Country 385BR has 4 slideouts that use cables. I'd be interested in getting some opinions of: 1. The benefits of the cable slideout systems 2. Suggestions for keeping them in good working order 3. Suggestions for preventing problems 4. How can they manually be...

A while ago someone (cpcs07)posted on this topic-on how they purchased a 14’ awning to cover the slide and wished they had purchased one 14’6” instead. I have a 2023 Avenger 27DBS. Anyone else have any thoughts? The price jumps $162 for another 6”. We are finding the slide out is out way more...

RV: 2019 Arctic Wolf 298QSL8 5th Wheel Problem Slide: Dinette (passenger side) So we were sitting around our dinette and there was a sort of bang! and the floor dropped. You could see it moved down about an inch from the inside. I'm a big guy, and we're full-timing, so it sees probably more...

My bedroom slide errored out due to low power (my mistake) when extending. Went through the reset procedure. I had to reset the stops as I was getting the seven red light flashes. The issue is one of the two motors does not work. I hear a click when attempting to engage the motor, but no...

I just purchased a 2006 M30V Minnie winnie and I notice that the bedroom slide goes out twice as fast as the living room slide. Questions: 1. Is this normal 2. Are both slides hydraulic or gear driven. 3. What should I check if this is not normal 4. If it is hydraulic, where is the reservoir to...

Hello, We recently purchased a used 2022 Wildwood 31KQBTS. When viewing the RV the slides were open. Now that we have it home we cannot get them to open again. When pushing the slide out button, it does make a noise that sounds powerful. We are not 100% that the battery is good, we have charged...

Riverstone Legacy 38RE. Tire tread came off under the kitchen slide and tore out all the wiring. Rewiring has been a pain but the A/C lines were pretty straight forward. The D/C not so. Has anyone seen this item? What is it and how is it wired into the D/C wiring? It was found loose in the...

Hi everyone, I have a 2018 Cougar. Like many others I have the rotten slide floor problem. My trailer is scheduled for slide floor replacement. I have looked at lots of You Tube videos on this problem and how adding slide skis will help prevent water from getting in along the bottom edge of the...

I have a 2000 Ultimate Advantage. I am currently working on replacing the adjustment bolts and plastic glides. I am having difficulty finding the glide strips that are used with vinyl or tile floors - wood or composite wrapped in a felt-like material. A part # and source would be greatly...

Has anyone ever had an issue when opening or closing the slides that both front slides work off the same switch? My 2010 330TS has this problem since I bought it. The bedroom slide works off one switch but the 2 front slides open together on one switch and close together on another. One of the...

I have a 2005 Keystone Sprinter 259RBS that I stay in during the work week. There is a slow seeping leak under the couch on the right side window of the slide out. I cannot figure it out or have any clue where it is coming from?! I have searched for any holes, spaces that need sealed and I...

Hi everyone I hope I'm posting this in the correct forum if not will the admin please move to the correct place for me. I'm trying to find the parts to replace the four brackets that are attached to the rear of the camper that the rails holding the slide out connect to. I'm going to attach a...

I have 21 37TS. Exploring options for adding a slide out BBQ on the passenger side. Who has done it? Pics and such would be great!

When closing the slide on my NoBo 19.6 should I get all the leaves off of the top of the slideout.?

NoBo 19.6. The curved plastic shower screen glides on rollers in a track on the top and bottom. The screws on the rollers vibrate out leaving the doors all wonky. I’m in my 3rd repair and using lock tight on the screws this time. 3 miniature hands would make the job easier. Has anyone wrestled...

https://balrvproducts.com/wp-content/uploads/downloads/tech/RVTI_ACCU-SLIDE-TRAINING-PRESENTATION.pptx