triplethreat

'B' is right next to 'N' on the keyboard and 40 runs through NC, so that'd be my guess. Mark B. Albuquerque, NM

I've read this many times and heard it said too.....Thursdays are usually the highest tractor/trailer truck volume on the road....so...

I had one custom made (sized) from a company called "Covers & All" They are an online company and I had it made in early 2019 right...

I have not personally been through that area since the wash out and ongoing repair of the area. I'm attaching a picture from google...

That post is over 5 YEARS old, and is now being closed.

That was the case with my Momentum. Granted, it is a 2018 model, so they may do things differently now and NOT put the step frame...

Opening slides on a trailer that is not level, or very close to it is in my opinion, somewhat risky. I'll use "nose" high as an...

This is what I did when I had a Can Am Spyder, which had very low clearance issues also. The ramp is raised up off the ground about 6"...

Thanks all for all the inputs, lots to digest for sure. I'll get it on the scale with this new F250 and the E rated tires. I figure i'm...

I run the door sticker pressure too.....75psi on the front, and 65psi on all four rear tires. I basically never change those...

Whatever truck you have, it has a GVWR sticker on it. That is the MOST that the truck and it's payload should ever weigh....period. So...

Folks, please keep it civil and avoid personal attacks. Over the weekend, I edited a couple of messages here to remove such comments...

Feeling superior to others has never been one of my goals in life. And just as a reminder about how forums work......opinions can be...

Well, a typical 5th wheel camper will normally put down at least 20% of it's weight, as pin weight and many times it can be higher. I...

Care to share what the payload capacity on that truck was.....if you remember?