chuckster57

About Latest activity Postings

  • Loading…
    • chuckster57
      chuckster57 replied to the thread Cats???.
      My brown point Siamese cat went across the country with us perched on the ice chest in the back seat. He passed shortly after, and my...
    • chuckster57
      chuckster57 replied to the thread New Solar.
      I used to open a wall, drill from the inside. Run the wires and reattach the wall.
    • chuckster57
      chuckster57 replied to the thread Furnace.
      Did you just refill a propane cylinder? If so turn them off, remove the pigtails for 30 seconds. Reattach them, and open the cylinder...
    • chuckster57
      chuckster57 replied to the thread How to change out tv.
      Raise the tv and then look at the back of the tv. It may have 4 screws holding it or 4 “buttons” that fit into holes. If it has the...
    • chuckster57
      chuckster57 replied to the thread Add.
      Welcome to the forum :wlcm: Lots of good information and loads of great people here.
    • chuckster57
      You wont find schematics for any of Keystones products. What thermostat do you have?
    • chuckster57
      chuckster57 replied to the thread Slide Timing.
      Depends on how bad the failure is unfortunately. If you locate the controller, there is an override procedure, if that doesn’t work then...
    • chuckster57
      chuckster57 replied to the thread Slide Timing.
      I can say that the time allowed for replacement is totally inadequate. Last one I had to actually cut the guide block at the shoe to...
    • chuckster57
      chuckster57 replied to the thread Water pump blowing bubbles!.
      Here is some good information https://www.bandbmolders.com/wp-content/uploads/2018/08/Nautilus-P4-User.pdf...
    • chuckster57
      Two terminals- should be labeled "bat" and "load" Battery is from the power source load is to the circuit
    • chuckster57
      chuckster57 replied to the thread Slide Timing.
      If you look at the tag on the column of your bedroom slide there will be a V number and it may or may not be an inverted rack. The V tag...
    • chuckster57
      The floor is attached to the walls from the bottom side. To do it properly, the slide needs to removed and laid on its back. Not an...
    • chuckster57
      chuckster57 replied to the thread Slide Timing.
      I use a tape measure, numbers don’t lie.
    • chuckster57
      chuckster57 replied to the thread 2021 Springdale 1740rk.
      If your slide has the schwintec mechanism, look at the “V” tag on the column. If it’s an “inverted” rack and falls within a certain time...
    • chuckster57
      Here you go, if it’s a Lippert system: https://techsupport.pdxrvwholesale.com/wp-content/uploads/2019/03/Lippert-LIP-Sheet-0071.pdf
  • Loading…

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top