ChuckS

About Latest activity Postings Resources

  • Loading…
    • ChuckS
      ChuckS replied to the thread No hot water.
      If you have NO 120 volt switch outside on the suburban WH and the element is good then first place I would be looking at is the remote...
      • IMG_2510.jpeg
      • IMG_2512.jpeg
    • ChuckS
      Yup I drain my water heater after every trip .. this removes the anode particles that have fallen to the bottom of the tank … and IMO...
    • ChuckS
      ChuckS replied to the thread Above slide wiper seal.
      If there is an actual gap along that top wiper seal and the seal itself isn’t damaged I would be concerned about a sagging slide out...
    • ChuckS
      ChuckS replied to the thread What blew my converter?.
      First thing I woolen be checking is that 30 amp 120VAC plug you are plugged into at the house and verify it’s actually delivering 120...
      • IMG_2493.jpeg
    • ChuckS
      ChuckS replied to the thread How to Remove Shower Doors?.
      As others stated .. you have to remove the top rail and doors at the same time based on the style of shower doors you have installed
    • ChuckS
      I’d be wondering why you had to turn the drums and replace the magnets on that axle… the other axle was ok I gather ..
    • ChuckS
      ChuckS reacted to Towinghome's post in the thread Breaker tripping at pedestal with Like Like.
      I've have a 2120 3120rl legacy edition. I have had the breaker at the pedestal trip, at two different campgrounds, trip only once during...
    • ChuckS
      First thing I’d check is the charge status of the battery.. The converter output when on shore power is most likely making up for the...
    • ChuckS
      Since the system ( hydraulic pump ) motor works fine in the OPs other modes of operation and only fails with retract all I don’t think...
    • ChuckS
      ChuckS replied to the thread Schwintek Slide Part?.
      You will need to fix this else you will have slide out issues . Don’t know of yo7 have the standard or inverted style Schwintek slide...
    • ChuckS
      ChuckS replied to the thread Schwintek Slide Part?.
      It’s the gib block Read this PDF for pictorial of the upper and lower bearing guide block assy and gib block...
    • ChuckS
      I had always assumed the pressure switch functioned all the time .. but after taking the Lippert on line hydrauilc level up course they...
    • ChuckS
      There is ONE component that is activated ONLY during Retract All operation.. The Pressure sensor located on the retract manifold .. I...
    • ChuckS
      ChuckS replied to the thread Furnace overheating.
      The furance not only pulls air from the return vents..it also pulls air from underneath the flooring and coroplast area so it should be...
      • IMG_2461.png
    • ChuckS
      ChuckS replied to the thread InCommand Panel.
      Of course it is . Looks like you have the NCS35 series In Command .. the BCM has two connections that connect to the display panel ...
      • IMG_2459.jpeg
      • IMG_2460.jpeg
  • Loading…
  • Loading…

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top