Added "C" shaped shims to take out excessive play of the yoke. Also shortened the sleeve between the yoke tubes so it did not limit the adjustment ran
Added "C" shaped shims to take out excessive play of the yoke. Also shortened the sleeve between the yoke tubes so it did not limit the adjustment ran
Added a plate to the bottom of the u bolt for the bar jacks to prevent it from deforming and loosing clamp load.
Used supplied plate, intended for underside, on top of the frame and added a new plate to the bottom to prevent the u-bolt from deforming and loosing
Nylon tube to protect the wires from the u-bolt threads. The nylon tube along with the nylon tube on the opposite side of the frame rail prevents the
Machined a large diameter disk to distribute the load of the clamp screw on the bar jacks.
Grease fitting added since hitch head is only taken off in the fall. Replaced factory grease at all bearings with marine grease. Also use the marine
Yaroslow

Added "C" shaped shims to take out excessive play of the yoke. Also shortened the sleeve between the yoke tubes so it did not limit the adjustment ran

There are no comments to display.

Photo information

Category
Keystone Forums Albums
Album
ProPride P3 Hitch Mods
Added by
Yaroslow
Date added
View count
53
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top