RV News RVBusiness 2021 Top 10 RVs of the Year, plus 56 additional debuts and must-see units → ×
 

Go Back   Keystone RV Forums > Keystone Fleet | Keystone RV Models > Travel Trailers
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 07-24-2018, 07:01 PM   #1
bspiek
Member
 
Join Date: Aug 2017
Location: Moorhead
Posts: 31
2015 Springdale slide problems

Won't move out, or in...13.6 volts on battery and plugged in to the house.

Found the manual operation nut and my 1/4 drive impact isn't moving it in either direction.

Any other ideas for me?
__________________

bspiek is offline   Reply With Quote
Old 07-25-2018, 02:06 AM   #2
ctbruce
Site Team
 
ctbruce's Avatar
 
Join Date: Dec 2015
Location: Kansas City
Posts: 3,879
Is something jammed up underneath of it?
__________________

__________________

Chip Bruce, RPh
Kansas City, MO
2016 Impact 312
2017 Silverado 3500HD SRW
ctbruce is offline   Reply With Quote
Old 07-25-2018, 02:49 AM   #3
xrated
Senior Member
 
xrated's Avatar
 
Join Date: Oct 2016
Location: "Murvil, TN
Posts: 1,746
Don't quote me on this, but if I'm not mistaken there is a brake release lever on the end of the motor assembly. Check that out and if it's there release it and try it again.
__________________
2016 F350 King Ranch Crew Cab Dually Diesel 4x4
2018 Grand Design Momentum 394M
2019 Can Am Spyder RT Limited (Phoenix Orange)
Excessive payload capacity is a wonderful thing

"If it ain't Fast....It ain't Fun"
xrated is online now   Reply With Quote
Old 07-25-2018, 04:08 AM   #4
bspiek
Member
 
Join Date: Aug 2017
Location: Moorhead
Posts: 31
Nothing is jammed that I can see.

I will roll under it again after work and take a look to a brake lever. Thank you.
bspiek is offline   Reply With Quote
Old 07-25-2018, 08:32 AM   #5
Freeheel4life
Senior Member
 
Join Date: Nov 2017
Location: Boise
Posts: 220
Yours is much newer than mine and may be a different design, but when I had issues with mine a small impact wouldn't cut it. Used a good sized 3/8" drive ratchet and moved it by hand.
If yours is the same as mine when you go this route you will feel where its binding and you can then stop and look for where the issue is.
My issue was also the 30A thermal breaker at the trailer frame up front. Mine had the 2 outdoor lights wired into the same circuit as the motor thru the breaker so if you have no lights theres a good chance that you have no power to the switch as well.
Good luck.
__________________
97 F250 7.3L
06 Springdale 269RLLS
Freeheel4life is offline   Reply With Quote
Old 07-25-2018, 11:21 AM   #6
xrated
Senior Member
 
xrated's Avatar
 
Join Date: Oct 2016
Location: "Murvil, TN
Posts: 1,746
Quote:
Originally Posted by bspiek View Post
Nothing is jammed that I can see.

I will roll under it again after work and take a look to a brake lever. Thank you.
Forget my last comment. I was thinking about the electric bed in the garage having a brake lever. I've got cable operated slides too and my control is over the top of the slides and IN the trailer, not under it. Sorry, my bad.
__________________
2016 F350 King Ranch Crew Cab Dually Diesel 4x4
2018 Grand Design Momentum 394M
2019 Can Am Spyder RT Limited (Phoenix Orange)
Excessive payload capacity is a wonderful thing

"If it ain't Fast....It ain't Fun"
xrated is online now   Reply With Quote
Old 07-25-2018, 02:03 PM   #7
Voyager
Member
 
Join Date: Jan 2015
Location: Vancouver BC
Posts: 48
The 30amp fuse in the electric panel on mine has blown a couple of times, replaced and worked fine,I replaced the fuse with an auto reset circuit breaker and itís working fine, mine is a 2015 267bhwe. I tried moving slide in with my 18v drill just to reassure myself that it would work in case of a problem, I used a Ryobi 18v with a high and low setting, would not move it on the high setting but worked fine on low. good luck!
__________________
Springdale 267bhwe- 2015
Ram 1500 crewcab hemi 8spd tran. - 2014
Previous 05 Dutchman 18B
2 Champion 2000's
Voyager is offline   Reply With Quote
Old 07-25-2018, 04:07 PM   #8
bspiek
Member
 
Join Date: Aug 2017
Location: Moorhead
Posts: 31
Slide will move using the 18 volt drill, so it's looking like an electrical issue. All the fuses test ok with the volt meter, but I don't think I'm getting voltage to the switch.

I'm going to bring the drill with and drag my large backside under the camper to run the slide out this weekend to keep the reservation we made a few weeks back.

Anyone know where to find a wiring diagram for one of these units?
bspiek is offline   Reply With Quote
Old 07-26-2018, 02:53 AM   #9
ctbruce
Site Team
 
ctbruce's Avatar
 
Join Date: Dec 2015
Location: Kansas City
Posts: 3,879
Quote:
Originally Posted by bspiek View Post

Anyone know where to find a wiring diagram for one of these units?
No such beast exists from Keystone. You may find a hand drawn one by googling.
__________________

Chip Bruce, RPh
Kansas City, MO
2016 Impact 312
2017 Silverado 3500HD SRW
ctbruce is offline   Reply With Quote
Old 08-04-2018, 11:00 AM   #10
SR71 Jet Mech
Member
 
SR71 Jet Mech's Avatar
 
Join Date: Aug 2018
Location: Greenwood
Posts: 62
If you have a volt meter, check the voltage at the motor when switch is engaged either in or out. If no voltage there, check the switch. Check continuity of switch. In neutral (center) position it will read infinity. In either the in or out position it should read zero. (Switch unplugged). Then while you’re there check for 12v. (DC voltage btw)
SR71 Jet Mech is offline   Reply With Quote
Old 08-04-2018, 02:37 PM   #11
bspiek
Member
 
Join Date: Aug 2017
Location: Moorhead
Posts: 31
I ended up taking the cover off the fuse panel, and surprise there was one more 30 amp fuse I could not see with the cover on. Oops.
__________________

bspiek is offline   Reply With Quote
Reply

Tags
slide, springdale

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by the Keystone RV Company or any of its affiliates in any way. Keystone RVģ is a registered trademark of the Keystone RV Company.


All times are GMT -8. The time now is 05:09 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
×