RV News RVBusiness 2021 Top 10 RVs of the Year, plus 56 additional debuts and must-see units → ×
 

Go Back   Keystone RV Forums > Keystone Fleet | Keystone RV Models > Travel Trailers
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 05-01-2017, 01:31 PM   #1
floorspy
Junior Member
 
Join Date: Mar 2016
Location: Visalia, CA
Posts: 2
Removeable table floor brackets on slideout unsecured

2015 Passport Ultralite, floor brackets that hold removeable table to floor in slideout installed over carpet then screwed into floor came loose, table very wobbly. Anyone have fix or solution for this problem?
__________________

floorspy is offline   Reply With Quote
Old 05-01-2017, 02:02 PM   #2
Frank G
Senior Member
 
Frank G's Avatar
 
Join Date: Feb 2017
Location: Dade City
Posts: 1,012
If these are the round metal post holders, pull the screws, rotate a little and screw it down again. Careful to not over tighten.
__________________

__________________
2017 Laredo 325RL
Travelers Rest Resort
www.travelersrestresort.com
Frank G is offline   Reply With Quote
Old 08-26-2017, 03:16 PM   #3
floorspy
Junior Member
 
Join Date: Mar 2016
Location: Visalia, CA
Posts: 2
Thanks, I did this and seems to be holding. We are also very careful with leaning on table.
floorspy is offline   Reply With Quote
Old 08-27-2017, 02:49 PM   #4
Kitesurfer
Junior Member
 
Join Date: Jun 2017
Location: Davidsonville
Posts: 5
We had the same issue in the Passport 2400bh. We rotated and I was going to install in the same part of the carpet. But I measured the spread on the table top holes and realized that the legs brackets were initially spread about 1" further apart as compared to the table top. When I aligned it perfectly it wobbled a lot less since the posts slid in much further and straighter.
Kitesurfer is offline   Reply With Quote
Old 08-28-2017, 10:03 AM   #5
PhillyPhan
Junior Member
 
Join Date: Aug 2017
Location: Mesa
Posts: 11
Do you know what size/type screws are used to bolt these down? We just picked up a used Cougar and the previous owner removed them because the table broke. He misplaced the screws so now I can't reinstall them. Not sure how long of screw is needed or can be used.
PhillyPhan is offline   Reply With Quote
Old 08-28-2017, 04:30 PM   #6
Kitesurfer
Junior Member
 
Join Date: Jun 2017
Location: Davidsonville
Posts: 5
I'm not a 100% sure. It was approximately 5/8" or 3/4"pan head phillips screw.
__________________

Kitesurfer is offline   Reply With Quote
Reply

Tags
floor, rack, slide, slideout

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by the Keystone RV Company or any of its affiliates in any way. Keystone RVģ is a registered trademark of the Keystone RV Company.


All times are GMT -8. The time now is 01:24 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
×