Little red light in converter says blown fuse

[tundra246]

I have 2011 bullet 246rbs and my converter has the 2nd from the top led light on but the fuse and circuit is fine .Its the fuse fore the lights over the bed and they work fine i canpush on the fuse and the red light will go off and the bed room lights will still work but as soon as i let go of the fuse red light comes back on.I know that fuse is fore the lights over the bed cause if i pull the fuse they do not work ,Should i worry about this i do dry camp quit a bit but i don't think it will use much power.

[JRTJH]

It sounds llike a cold solder joint on the LED circuit for the light. If it's under warranty, take it back and let them replace the fuse panel. If it's not under warranty, disconnect the 120 VAC and the batteries (12VDC) and take the fuse panel out. You'll probably find a broken solder joint or a corroded circuit board contact where you've been pushing to get the light to go out.

Good Luck

John

[Terrydactile]

Yep, you've got a broken circuit for the LED causing it to light up like when the fuse is blown. Probably a loose solder joint as mention before. Obviously the fuse is not blown.