End caps for table legs

[wrvond]

My camper has the free standing table that I think is pretty common - especially in Cougar half ton models. It arrived here missing one of the rectangular caps/plugs in the four base legs. I ordered a replacement from McMaster-Carr and it was a perfect fit.
However, I wasn't able to order just one or two. I had to order a bag of 25 of them. I'm figuring I might lose one, maybe two more in my lifetime, but that leaves twenty-two of them with no purpose in life.

Description: Snap-in for 1.83"-1.95" long X 0.84"-0.95" wide inside.

If anybody needs one feel free to send me a PM.

[RollaMo]

They must just put whatever is available on these when assembled.

Our 2022 24RDS (same free standing table as yours) has "round" adjusters on the bottom.
Even though they had a plastic pad on the bottom, I went to Lowe's and got some felt pads to put on them.

[wrvond]

Originally Posted by RollaMo

They must just put whatever is available on these when assembled.

Our 2022 24RDS (same free standing table as yours) has "round" adjusters on the bottom.
Even though they had a plastic pad on the bottom, I went to Lowe's and got some felt pads to put on them.

I'm thinking you are referring to the "feet" which are adjustable and screw into the bottom of the base legs. Those base legs are horizontal or parallel to the floor and are hollow rectangular tubes. These plugs simply fill the open ends and cover the sharp edges and corners that can dig into the vinyl floor. The plugs are also used between each of the vertical sections at the hinges. That's the picture I used from my table that arrived all twisted up with broken hinges.

I think felt pads on the feet is a great idea. I have a bunch of those somewhere (just saw them recently). I'll have to find them again and stick some on there too.

[RollaMo]

Originally Posted by wrvond

I'm thinking you are referring to the "feet" which are adjustable and screw into the bottom of the base legs. Those base legs are horizontal or parallel to the floor and are hollow rectangular tubes. These plugs simply fill the open ends and cover the sharp edges and corners that can dig into the vinyl floor. The plugs are also used between each of the vertical sections at the hinges. That's the picture I used from my table that arrived all twisted up with broken hinges.

I think felt pads on the feet is a great idea. I have a bunch of those somewhere (just saw them recently). I'll have to find them again and stick some on there too.

OK, I see what you are talking about now.
Not sure why it didn't see that the first time.