I have a 2013 viewfinder and found that when it was put together they didn’t cut the screws down. Opening and closing of the slide outs eventually broke the wires. I spliced them myself. This was definitely a manufacturer defect but I got know where with dealer or manufacturer. Took taking off doors etc to access the wires. I did go around and found screws not trimmed on the other slide. Cleaned up everything to avoid same issue.
Any idea how I might run new wires from under the slideout up the outer wall to the top two light in my slide.
Seems after a two hour drive with trailer the two lights on my slide out are shorted. Both of them (LEDs) will not turn on. There is 13.6 volts on the wire going in through the bottom of the slide. Nothing at either light.
Think that one of the staples has shorted out the wire. Seems impossible to pull the wires through the bottom to snake new wires through. Think the wires are stapled up the wall and along the top of the slide.
We pull on both ends of the wires and can feel nothing on either end. Seems a staple shorting the wire is the most likely cause.
Any thoughts how we might be able to run a new wire to either of the lights ?
Anyone ever run into this issue ? What was your solution. Would be delighted if someone has some experience with this one !
Thanks everyone
Kid
[/QUOTE]
Linear Mode
