|
02-28-2016, 12:14 PM
|
#1
|
Senior Member
Join Date: Dec 2013
Location: Great Falls, MT
Posts: 322
|
Furnace not working
I tried searching but on my phone more difficult...
Not an emergency since I've dealt with it all weekend so far.
Set up on Holter lake in Montana. Didn't notice at first because I set my Dometic 2 zone thermostat close to what the inside temp was. How ever, my furnace is not kicking on at al. No clicking no nothing. The thermostat looks normal. Checked and I have gas(stove top and fridge are both working in propane). Checked the 12 volt fuse and it's fine.
I'm not even sure what brand of furnace I have or where to start trouble shooting.
Any assistance would be appreciated.
I will update after I attempt suggestions.
Thanks
Sent from my iPhone using Tapatalk
__________________
2016 Alpine 3601RS
6500 Onan
2016 Chevrolet 2500 LTZ/Z71
|
|
|
02-28-2016, 05:11 PM
|
#2
|
Senior Member
Join Date: Apr 2011
Location: Arrey,
Posts: 2,368
|
shov, Howdy;
Have you tried moving the thermostat up to activate the A/C? Mode needs to be in AUTO.
Once it kicks in try adjusting the thermostat back into the heating range.
Don't know if yours is analog or digital (the more info you give us the better
we can then help you), if the above doesn't help then your circut-board
(for the heater), may be bad.
Should be some info packets that came with the trailer.
hankaye
__________________
Striving for a less complicated life since 1949 ...
Home: 2008 Cougar 278 RKS
T.V.: 2004 F-250 4X4, Level III BulletProofed , Detroit Tru-Track Differential (915A550)
Dog: 2006 Border Collie (Rascal) aka Maximum fur dispersal unit. (08/04/2006 - 12/16/2017) RIP.
|
|
|
02-28-2016, 06:26 PM
|
#3
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,235
|
Since you have a dual zone thermostat, have you set the mode to auto as suggested? You can also go to the zone that controls the furnace and try that.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
02-29-2016, 07:46 AM
|
#4
|
Senior Member
Join Date: Dec 2013
Location: Great Falls, MT
Posts: 322
|
Sorry for the lack of info...
It is a digital thermostat and dual zone
So I set zone 1 to heat and the fan to auto, increased and decreased the temp to where it should have set the heat to come on, but notta...
So, I am guessing, the next step is to investigate the board...
I will keep everyone updated...
__________________
2016 Alpine 3601RS
6500 Onan
2016 Chevrolet 2500 LTZ/Z71
|
|
|
02-29-2016, 08:00 AM
|
#5
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,235
|
I will look in my Dometic service manual and see if it has any user friendly tests.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
02-29-2016, 05:41 PM
|
#6
|
Senior Member
Join Date: Dec 2013
Location: Great Falls, MT
Posts: 322
|
Thanks chuckster57!
Sent from my iPhone using Tapatalk
__________________
2016 Alpine 3601RS
6500 Onan
2016 Chevrolet 2500 LTZ/Z71
|
|
|
03-01-2016, 01:03 PM
|
#7
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,235
|
You have a PM
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
03-01-2016, 01:14 PM
|
#8
|
Senior Member
Join Date: Dec 2013
Location: Great Falls, MT
Posts: 322
|
Got it. Thank you!
Sent from my iPhone using Tapatalk
__________________
2016 Alpine 3601RS
6500 Onan
2016 Chevrolet 2500 LTZ/Z71
|
|
|
06-02-2016, 04:46 AM
|
#9
|
Senior Member
Join Date: Dec 2013
Location: Great Falls, MT
Posts: 322
|
Just wanted to provide a little update which may help someone else down the road. I trouble shot with a tech and the 99.9% solution was to change out the control board on my furnace. After wrestling with the poor placement and removing the furnace and replacing the control board... And not being the solution. I took my unit to the dealership. They then removed the furnace and bench tested everything and it tested good... They happened to have removed the thermostat from the wall after reinstall and low and behold there were two loose wires to the back of the thermostat. I feel stupid but I am back up and running. Thanks to everyone who provided suggestions and PM'ed with offers of help!
Sent from my iPhone using Tapatalk
__________________
2016 Alpine 3601RS
6500 Onan
2016 Chevrolet 2500 LTZ/Z71
|
|
|
06-02-2016, 05:03 AM
|
#10
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,235
|
Glad to hear all is good.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
06-05-2016, 08:55 PM
|
#11
|
Senior Member
Join Date: Nov 2012
Location: Fruitland
Posts: 3,357
|
Thanking for posting the fix.
__________________
2013 24RKSWE (27ft TT) Cougar 1/2 ton series SOLD 10-2021
2013 Ford F350 4x4 CC 6.7 engine, 8 ft bed, 3.55 rear end, lariat package
Retired from Oregon State Police in 2011 than worked another 9.5 years as a small town traffic cop:
As of 05-2020, I am all done with 39 years total police work. No more uniforms for me.
|
|
|
|
Thread Tools |
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|