info on bolt in floor

[hitchikerman]

I have a Keystone 2020 Cougar 315 RLS and I have a which looks like a 1/2 bolt popping though the floor board right next to my island and I have no idea what this could be other then something to do with a slide frame rail or something else. Anyone have any suggestions what is going on?

[jasin1]

Originally Posted by hitchikerman

I have a Keystone 2020 Cougar 315 RLS and I have a which looks like a 1/2 bolt popping though the floor board right next to my island and I have no idea what this could be other then something to do with a slide frame rail or something else. Anyone have any suggestions what is going on?

Can you take a picture of it…stand back a little to get the whole area in view

[Blueswede]

I’ve had the same issue with our 2021 Cougar. It’s a screw that has popped thru the floor next to the island. I’ll post a picture later today.

[bgrhrdt]

Same problem with my 2021 Cougar 290RLS. It was popped up about 3/4", tenting the linoleum flooring. I was able to push it more flush with the palm of my hand, and then took it to the dealer who fixed it. I didn't question him about what it was; he said it was a common problem. (It was also next to the island (about 1 1/2 ft from the island toward the rear of the trailer)

[jasin1]

I’ve been interested because I hear a noise in the floor when I walk past the island on the dinette side of my 315 rls

[cougarbait]

Same thing in our 5'er, near our bathroom. I found it by tripping over it.... I thought is was a loose nut that was covered by the linoleum from the factory. Is it a loose through bolt that can be tightened from underneath?

[Shasta Bob]

Ive have the same problem the dealer said they will cut the floor and tighten it or remove it. there must be a problem somewhere?

[Shasta Bob]

Photos of my 2019 315 RLS

[BookPaul74]

Originally Posted by Shasta Bob

Ive have the same problem the dealer said they will cut the floor and tighten it or remove it. there must be a problem somewhere?

I had the same problem on my 2014 Cougar 337FLS. It was right as I came in the door by the cabinet for the sink. It fixed itself after a while when it worked out of the vinyl flooring and left a little round tab sticking up. It was a Philips head screw. I was afraid that the “nut” on the other end may have come off.

I was able to use the Philips driver bit and tightened it down and then I just pushed the little vinyl button down in the hole. It doesn’t bother me because I have a carpeted door mat over it. Out of sight, out of mind. 😁