Quote:
Originally Posted by flybouy
The instructions on WDH is to adjust so that the front and rear drop as close to the same amount as possible. I haven't read the E2 instructions but that's what I'd go by v(the instructions for the hitch itself).
|
Front and rear drop would seem to make sense, but that is not what
E2 recommends. They say:
1. Meausre the height from the ground to fender when WDH is not used and tongue load is applied.
2. Measure the height when no weight is applied to the ball.
3. Determine the average of the two heights.
4. Adjust the WDH until the height is between the average and no load on ball condition.
5. Then check to see if the trailer is still level front to rear.
They claim that this is to prevent wear to the steering and front suspension of the tow vehicle.