Oil temperature gauge install
I've decided to go with the same B&M cooler used in the referenced thread and will be installing it this weekend. I'm going to follow the guide here and won't be using any rubber hose:
http://www.gmt400.com/forum/showthre...cooler-upgrade
Where the OP used an adapter pictured here, I'm thinking of using a brass tee and installing a temp sensor for a gauge in the cabin:
Is this a good place to do this? Which side of the cooler would be the inlet (fender side or center side) so I get the pre-cooled temp?
Thanks in advance!
__________________
Current:
'17 Winnebago Vista 31BE / Wife, pesky Eski and loco Toto dog
Former:
'15 Open Range 256BHS / '05 F350 CCLB RWD V10
'14 Keystone Passport 238ML / '13 GC Trailhawk Hemi
RIP Birch (pitbull)
|