301TR slide hitting and bending floor registers,any one else had this issue

[BigZ]

Floor registers are getting hit-and-run being uo corners by both slides when retracted

[chuckster57]

Welcome to the forum

year, make and model along with type of slide would be great information to help make an educated response.

[BigZ]

Originally Posted by chuckster57

Welcome to the forum

year, make and model along with type of slide would be great information to help make an educated response.

2021 301tr springdale

[chuckster57]

And what type of slide mechanism.

[BigZ]

Rack and pinion

[chuckster57]

Ok. You can adjust the room so the leading edge stays higher for a longer period of time. You have to be sure the room still seals when fully extended/retracted.

Start with the room about 1/2 way out. Look for the long bolts that are vertical at the ends of the square tubes. Lowering the bolt will raise the leading edge. Make adjustments about 1 turn at a time, tighten all the nuts and fully extend the room, then retract.

[BigZ]

Will give it a try ,registers need replacing as there all bent ,I'll look for something that is more flish with the lino