|
09-07-2019, 06:25 PM
|
#1
|
Junior Member
Join Date: Sep 2019
Location: el paso
Posts: 10
|
refer blow fuse twice
hi everybody
i have a 2020 raptor with norcold model 2118 (residential refrigerator), i replaced the 5 amp fuse but after 2 hours blows again, i don't want to go with the dealer because is a 2.5 hours from where i live and i don't have a truck to move it :'( :'(
|
|
|
09-07-2019, 06:47 PM
|
#2
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,349
|
Welcome to the forum.
A Norcold 2118 is an RV fridge that cools using a 110V element or a propane flame. It’s not a residential fridge that uses a compressor.
What 5A fuse is blowing?
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
09-07-2019, 06:53 PM
|
#3
|
Junior Member
Join Date: Sep 2019
Location: el paso
Posts: 10
|
only has 2 fuse, the one I'm talking about is inside of this black box
|
|
|
09-07-2019, 07:00 PM
|
#4
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,349
|
Ok. That black box is the control board. If your selling dealer didn’t include the owners manual you can get it here:
https://norcold.com/product/norcold-...-refrigerator/
There are any number of things than may cause your issue. Is it operating on shore power or batteries? Is the control set to AUTO? Or LP? Is it displaying any fault codes?
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
09-07-2019, 07:06 PM
|
#5
|
Junior Member
Join Date: Sep 2019
Location: el paso
Posts: 10
|
is working with electric power connected to a 50 amp source, is on automatic and right now has no power for the blow fuse
|
|
|
09-07-2019, 07:08 PM
|
#6
|
Junior Member
Join Date: Sep 2019
Location: el paso
Posts: 10
|
is not displaying nothing
|
|
|
09-07-2019, 07:11 PM
|
#7
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,349
|
Ok. Unplug from the 50A source, put another 5A fuse in see what happens.
Have you read any of the troubleshooting pages of the owners manual?
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
09-07-2019, 07:16 PM
|
#8
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,349
|
I’m leaning towards a short somewhere in the 12V circuit. Do you have an Ohm meter and are you familiar with its operation?
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
09-07-2019, 07:27 PM
|
#9
|
Junior Member
Join Date: Sep 2019
Location: el paso
Posts: 10
|
i used my last 5 amp fuse, i have a multimeter but i only used to test voltage
|
|
|
09-07-2019, 07:37 PM
|
#10
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,349
|
Ok. With the shore power cord disconnected, set the meter to OHMS. With the meter ON the display should read “1”, then touch the tips together and the display should read just about zero.
Then using the meter, put one probe on the fuse slot on the BOARD side and the other to a ground. If it reads zero then your board is most likely shorted out.
Since it’s a 2020, the refer is covered by warranty, and you may need to find a mobile technician that keystone will authorize payment to. You don’t really want to do a lot of “testing” as you may cause more damage and lose your warranty coverage.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
09-07-2019, 08:05 PM
|
#11
|
Junior Member
Join Date: Sep 2019
Location: el paso
Posts: 10
|
tomorrow i'm going to try again replacing the fuse, if blown again i'm going to call a mobile technician, i hope i can find someone on sunday. thank you for your help chuckster57
|
|
|
09-08-2019, 02:54 AM
|
#12
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,349
|
I would just find a mobile tech. It’s going to blow again
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
06-10-2021, 03:21 PM
|
#13
|
Junior Member
Join Date: Aug 2017
Location: Summit Point
Posts: 8
|
So, what was the fix? I am not under warranty and having the same issue.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|