Plumbing Part Identify (Water Heater Elbow)

[crownwire71]

Can anyone help identify this elbow (size also)? It connects to the brass fitting on the water heater. I had to replace my spray-port, which is not far from my water heater and while I was under the bunk I noticed that the slightest touch of the water line that connects to this 90 degree elbow causes it to leak profusely. It appears to be a female-female swivel elbow... but any search I conduct cannot find such a thing. Any help is appreciated.

2020 Keystone Bullet Crossfire 2200BH

[chuckster57]

Welcome to the forum

Both ends should have a cone washer, and I bet that’s what has failed.
It’s 1/2” line.

[jasin1]

Originally Posted by crownwire71

Can anyone help identify this elbow (size also)? It connects to the brass fitting on the water heater. I had to replace my spray-port, which is not far from my water heater and while I was under the bunk I noticed that the slightest touch of the water line that connects to this 90 degree elbow causes it to leak profusely. It appears to be a female-female swivel elbow... but any search I conduct cannot find such a thing. Any help is appreciated.

2020 Keystone Bullet Crossfire 2200BH

Possibly one of these not sure which one

[travelin texans]

Lowes, HD & Ace Hardware have a big variety of 1/2" pex fittings to look through. As Chuckster said it may only need the cone washer which should also be available at those stores.

[sourdough]

I've had those connections leak and all they needed was tightening. I figure you tried that. I've also had them leak and the soft rubber cone washer inside had been mashed crooked when the fitting was screwed on. I believe you can buy the rubber cones at most hardware stores or on Amazon if that is the problem.