Slider can & drive
Pix are upside down camera
Wear mark in actuator is @ frame hole & is in same quadrent, top both sides.
Had a problem pulling our slide in to break camp last light. Bottom side stopped about 8-12" out.
Extended it OK & didn't try again
Waited till morning light.
As we pulled it in heard a loud pop.
We found the STOP CAN bent. It showd up on pix from last year.
It looks like the actuator has been high since day 1 & scratching
Has scrape marks on actuator body & now a gouge in it.
Frame has marks etc now
One pix also shows actuator high in the frame hole when extended.
We have install & maintenance manuals showing vertical adjustment for leak fixes but....
Ideas?
|