Thought I would post this for anyone like me who doesn't like their ($300) Tailgater sitting on the ground.
Parts needed;
20' Schedule 40 1" PVC
8 X 90s
8 X Tees
All parts are 1" Schedule 40 PVC.
The top support square uses;
Cut 4 X 9 1/2"
Cut 4 X 1 1/2"
4 X Tees
4 X 90s
The bottom support square uses;
Cut 4 X 17 1/2"
Cut 4 X 1 1/2"
4 X Tees
4 X 90s
For the support legs I cut 4 X 25". The support legs are at an angle because the top square is smaller than the bottom. If you put the Tees in the middle of each cross piece, both top and bottom, I don't think you would have the angle's. But I was okay with it. I glued the top square and the bottom but left the support legs UN-glued so I could break it down for storage and transport. I plan on using 2 bungee cords and a 5 gal bucket, full of water as an anchor.