Connecting Solar Panels into the system?

[BookPaul74]

I'm getting ready to install 400 watt solar system on my 2014 Cougar 337FLS. I've ordered a battery box that will hold 4 6 volt batteries that will replace the single battery box in the front compartment. I can run the wiring down the wall between the bathroom and hallway, there a vent for the gray tank in the wall. I know where to drill the hole.

I replaced the WFCO 55 amp charger with a Progressive Dynamics Inteli-Charge 80 amp. Is there a way to tie into the fuse panel side of the breaker panel or could I use the second set of connections coming off the PD Inteli-charger.

Trying to keep from running two 10 ga wires to the front of the fifth wheel.

[roadglide]

Originally Posted by BookPaul74

I'm getting ready to install 400 watt solar system on my 2014 Cougar 337FLS. I've ordered a battery box that will hold 4 6 volt batteries that will replace the single battery box in the front compartment. I can run the wiring down the wall between the bathroom and hallway, there a vent for the gray tank in the wall. I know where to drill the hole.

I replaced the WFCO 55 amp charger with a Progressive Dynamics Inteli-Charge 80 amp. Is there a way to tie into the fuse panel side of the breaker panel or could I use the second set of connections coming off the PD Inteli-charger.

Trying to keep from running two 10 ga wires to the front of the fifth wheel.

Your doing a full house system connected to 8 amp converter ?