I recall a post somewhere describing a similar issue. Their solution was to install a plate “sandwich” in the passthrough to provide a mounting surface. The strongarms are not bearing any weight so the mount provided all the rigidity they needed.
On mine, (bumper pull) there is no crossmember where I wanted to mount the front inside strongarms because my water tank is there, so I bolted a 6’ length of 2” angle bar between the frame rails and attached the strongarm mount to the middle of that. If I recall, they suggest a maximum distance of deviation from square to allow for these variables
__________________
Rob & Amy
2019 Passport 240BH SL (current)
2024 Cougar 29BHL (on order, originally due late April, then pushed to early May, now pushed to early June)
2022 Ford F250 7.3L Godzilla Crew Cab FX4
|