Quote:
Originally Posted by Tom08
I don’t have the keytv box. I just have coaxial box with the boost button for the antenna and a box next to it with two coaxial cable that has a coaxial loop connected to it.
|
Then you have the "old setup".
The "satellite/cable" connector on the sidewall is where you connect either input. Inside, you'll find two "outlet boxes" One will have a jumper cable connecting them and the other will be the TV antenna power booster.
For satellite, remove the jumper, determine which is out, connect the out to your satellite receiver, connect the in to the panel and turn the antenna booster off.
For cable TV, leave the jumper cable connected, turn the antenna booster off and scan your TV for "cable channels"
For OTA (antenna reception) leave the jumper cable connected, turn the antenna booster on and set your TV for OTA and scan for channels.
Essentially, every time you change inputs, you have to reset the TV and rescan for channels.
Remember, Cable or satellite, booster off, OTA booster on.