Ground Control 3.0

[jdixon980]

Been camping since Saturday. When leveling I got a Jack error. I believe it was right rear. It sounded like it was raising rear, sounded like leveling slowed way down and beeped with error. I think rear was out of stroke. I was plugged into shore power when I was leveling. So I don’t guess it was low voltage. Any way the middle light was blinking on controller so I knew I was close to level. I just cut it off. So I am leaving Saturday. Can I push retract on controller then push rear, will the rear retract so I can raise front to connect to truck. I know I have to extend all jacks 6” and retract to reset controller. But I need to retract rear to be able to raise front. Is my logic correct?

[behrmr]

If you go to manual mode you will be able to manually retract your rear jacks then raise your front jacks and hook up. The thing will beep at you the whole time with the jack errors. Once hooked up rehome the jacks like you mentioned.

[markcee]

Here is a good video related to correcting the out of stroke error on the Ground Control system.

https://www.youtube.com/watch?v=-9Qh-8bR3JU

[rws262]

When leveling mine, it will try to level until one of them seems to work too hard, then it will "pop" and shut off, and come back with an error. I have not been plugged into shore power when leveling it. Is that a low voltage issue?

[travelin texans]

Originally Posted by rws262

When leveling mine, it will try to level until one of them seems to work too hard, then it will "pop" and shut off, and come back with an error. I have not been plugged into shore power when leveling it. Is that a low voltage issue?

Yep! Most likely the pop is the circuit breaker tripping. Might want to have your batteries load tested at your local auto parts store.