Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 

Go Back   Keystone RV Forums > Keystone Fleet | Keystone RV Models > Fifth Wheels
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 06-20-2020, 11:38 AM   #1
Spletbr
Senior Member
 
Join Date: Apr 2019
Location: Newtown
Posts: 132
Auto connect for auto leveler does not react

I have the ground control 3.0 system. The last two times after disconnecting (dropped front jacks and unhooked) when I then go to push auto level nothing happens. No error code, no reaction. I do note that the "right" button light is blinking but I have to manually level. It just seems almost like the autolevel button is broken because nothing happens or changes. Any ideas/suggestions?
Spletbr is offline   Reply With Quote
Old 06-20-2020, 11:59 AM   #2
dutchmensport
Senior Member
 
Join Date: Jan 2013
Location: Indiana
Posts: 2,666
It sounds like your system need to have it's zero Point Calibration done. It does not know what "zero" is. Or if it worked in the past, it's been lost.

From the LCI manual:

The “Zero Point” is the programmed point that the unit will return to each time the Auto Level feature is used. The “Zero Point” must be programmed prior to using the Auto Level feature to ensure the proper operation of the system.

Note: Prior to starting this procedure, double check all connections on the controller, jacks, and touch pad.

1. Manually run the jacks to level the unit. This is best achieved by placing a level in the center of the unit and leveling it both front to back and then side to side. (See “Basic Jack Operation” for instructions on how to manually operate the system)

2. Once the unit is level, turn off the touch pad.

3. With the touch pad off, press and release the “FRONT” button (Fig. 1G) ten (10) times and then press and release the “REAR” button (Fig. 1J) ten (10) times.

4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set, Power to Exit” (Fig. 5).

5. To set the current position as the zero point, press the “ENTER” button (Fig. 1C).

6. LCD display will read “Zero Point stability check” (Fig. 6).

7. LCD display will read “Zero point set successfully” once process is complete (Fig. 7).

8. The system will set this point as its level state and the touch pad will turn off.

Down Load the PDF, Click here.
__________________
2019 Montana High Country 375FL
2014 Chevy Duramax HD 6.6 - 3500 Diesel Dully Long bed Crew Cab
dutchmensport is offline   Reply With Quote
Old 06-20-2020, 12:02 PM   #3
chuckster57
Site Team
 
chuckster57's Avatar
 
Join Date: Jul 2014
Location: Modesto
Posts: 20,238
unplug the control panel from the back, wait about 30 seconds and plug it back in. The lights that are blinking after unhooking are what the control module says is low. In your case it says (thinks) that the trailer is level front to rear but low on the right side.
__________________

2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.

Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
chuckster57 is online now   Reply With Quote
Old 06-20-2020, 03:14 PM   #4
Laredo Tugger
Senior Member
 
Join Date: Apr 2018
Location: South US
Posts: 712
I will add only to offer experience with the same issue and not to discredit the advice of any previous post that you might check your battery(s). I left my trailer for service at a dealer and got it back with one dead cell in my battery. After experiencing the same issues you (the OP) are having I learned (on this forum) that the 3.0 systems performance is very sensitive to low voltage.
A new battery (which I now keep on a tender and will not leave at any dealer in the future) solved the problems.
RMc
__________________
2018 Ram 3500 SRW Aisin Trans. HO CTD
Air Lift Bags -Curt 16K Slider Hitch
2017 Laredo 350 FB
Laredo Tugger is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by the Keystone RV Company or any of its affiliates in any way. Keystone RV® is a registered trademark of the Keystone RV Company.


All times are GMT -8. The time now is 04:54 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.