One tooth will change that end just about the right amount. Here’s the way we do it.
Use a good 3 or 4 ton floor jack, make a T using 2X6 lumber. Lift the room at the end you want to move, just enough to take the load off the roller pack. Remove one screw, lower the gear pack. Move the room by pushing/pulling and then put the gear pack back up and put the bolt back in. Lower the floor jack and try the room.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|