|
10-25-2020, 04:13 PM
|
#1
|
Junior Member
Join Date: Jul 2017
Location: Scottsbluff
Posts: 17
|
Can I put the awning motor in backwards?
Today we replaced the fabric on out 2011 Montana awning (Dometic electric).
After getting it replaced and rolled back up into the brackets, hit the extend switch, and nothing happened, hit the retract and it came out, but would not roll back up.
Did I somehow get the motor in the wrong way when I put it back together? I know when we rolled it up we rolled it the wrong way, so I will have to fix that, would that cause the issue?
Any suggestions/advice is welcome.
Thanks!
|
|
|
10-26-2020, 03:42 AM
|
#2
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,351
|
Was the motor “plug and play”? If you had to cut the wires then just reverse them and you’ll be good.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
10-26-2020, 07:46 AM
|
#3
|
Junior Member
Join Date: Jul 2017
Location: Scottsbluff
Posts: 17
|
Quote:
Originally Posted by chuckster57
Was the motor “plug and play”? If you had to cut the wires then just reverse them and you’ll be good.
|
I didn't need to cut any wires, just unplugged it before unrolling it before taking the old fabric off
|
|
|
10-26-2020, 08:12 AM
|
#4
|
Site Team
Join Date: Mar 2011
Location: Gaylord
Posts: 26,997
|
Quote:
Originally Posted by ErickW
Today we replaced the fabric on out 2011 Montana awning (Dometic electric).
After getting it replaced and rolled back up into the brackets, hit the extend switch, and nothing happened, hit the retract and it came out, but would not roll back up.
Did I somehow get the motor in the wrong way when I put it back together? I know when we rolled it up we rolled it the wrong way, so I will have to fix that, would that cause the issue?
Any suggestions/advice is welcome.
Thanks!
|
I think the part of your initial question (highlighted above) is your issue. If you rolled the awning fabric up the wrong way, then the motor would have to operate in the reverse direction to extend/retract the awning. Once your awning reaches the "fully retracted (stowed) position", then the motor will stop turning. If it was rolled up backwards, then it would actually be "fully extended" not retracted, and would stop working (at the shutoff switch limits)...
Manually extend the awning (you may need to decouple the motor to do so) and roll it up properly. That should fix your problem.
__________________
John
2015 F250 6.7l 4x4
2014 Cougar X Lite 27RKS
|
|
|
10-26-2020, 04:20 PM
|
#5
|
Senior Member
Join Date: Nov 2016
Location: Sussex, NJ
Posts: 471
|
Quote:
Originally Posted by JRTJH
I think the part of your initial question (highlighted above) is your issue. If you rolled the awning fabric up the wrong way, then the motor would have to operate in the reverse direction to extend/retract the awning. Once your awning reaches the "fully retracted (stowed) position", then the motor will stop turning. If it was rolled up backwards, then it would actually be "fully extended" not retracted, and would stop working (at the shutoff switch limits)...
Manually extend the awning (you may need to decouple the motor to do so) and roll it up properly. That should fix your problem.
|
If it is as simple is the awnings on my unit, just hold the switch in the retract position until it extends all the way and it will roll right around and retract all the way and your done. Release the switch. It will then operate as normal.
__________________
2016 Fuzion 414 Chrome
2016 Ford F450 Super Duty King Ranch
|
|
|
10-26-2020, 05:42 PM
|
#6
|
Site Team
Join Date: Mar 2011
Location: Gaylord
Posts: 26,997
|
Quote:
Originally Posted by MattHelm21
If it is as simple is the awnings on my unit, just hold the switch in the retract position until it extends all the way and it will roll right around and retract all the way and your done. Release the switch. It will then operate as normal.
|
If your awnings are Lippert Solara awnings, then yup, it's really that simple. The Solara awnings don't have a limit switch at the end of awning travel and the motor will continue to run, winding the fabric onto the roller tube "backwards"... When that happens, pressing the "extend/retract" switch backwards will usually fix the problem.
Dometic and Carefree awnings typically have a limit switch on the motor and at the end of the awning travel, that switch "shuts off the motor to prevent the fabric from rolling up backwards".... I haven't worked on a Dometic or Carefree awning newer than about 2013, so the newer ones may not have that limit switch... That said, not having worked on one newer than 2013 should be a "testament to quality/endurance" in those brands.... I replaced two awning motors in Solara awning last month, so......
__________________
John
2015 F250 6.7l 4x4
2014 Cougar X Lite 27RKS
|
|
|
10-27-2020, 08:46 AM
|
#7
|
Senior Member
Join Date: Oct 2019
Location: Central FL
Posts: 1,090
|
Quote:
Originally Posted by JRTJH
If your awnings are Lippert Solara awnings, then yup, it's really that simple. The Solara awnings don't have a limit switch at the end of awning travel and the motor will continue to run, winding the fabric onto the roller tube "backwards"... When that happens, pressing the "extend/retract" switch backwards will usually fix the problem.
Dometic and Carefree awnings typically have a limit switch on the motor and at the end of the awning travel, that switch "shuts off the motor to prevent the fabric from rolling up backwards".... I haven't worked on a Dometic or Carefree awning newer than about 2013, so the newer ones may not have that limit switch... That said, not having worked on one newer than 2013 should be a "testament to quality/endurance" in those brands.... I replaced two awning motors in Solara awning last month, so......
|
I believe you are correct here, John. The newer Dometic/Carefree awnings will continue to turn like the Lipperts do. A neighbor we knew had been there and done that.
__________________
2023 Cougar HT 23MLE
2020 F250 XLT CC 6.2 4WD
|
|
|
11-03-2020, 08:24 AM
|
#8
|
Junior Member
Join Date: Jul 2017
Location: Scottsbluff
Posts: 17
|
It is a Dometic 8952 awning, on a 2011 Keystone. Today I will try flipping the motor over, failing that, I may try rewinding the torsion spring, see if I can get it to help the roll up process.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|