self levelers

[Chinomax]

So I use my 4 point auto level system and the front end is too high. Is there a way to adjust the unit underneath to allow for a lower attitude? I have been manually lowering the front jacks but it will not allow me to re-lower the rear jacks to firm things up. Any ideas? Thanks Chino

[chuckster57]

If your using LCI's ground control 3.0 here is the procedure:

After you have all 4 jacks on the ground, use manual mode to level the unit. Make sure it is level front to back and side to side using a level ( I use a 4') the longer the better.

Once the unit is level, turn the control panel off. Press the "front" pad 7 times followed by the "back" pad 7 times. The display should light up and give you the prompt to press "enter" for zero calibration.

If 7 presses doesn't do it, then try 10.

[Canonman]

Originally Posted by chuckster57

If your using LCI's ground control 3.0 here is the procedure:

After you have all 4 jacks on the ground, use manual mode to level the unit. Make sure it is level front to back and side to side using a level ( I use a 4') the longer the better.

Once the unit is level, turn the control panel off. Press the "front" pad 7 times followed by the "back" pad 7 times. The display should light up and give you the prompt to press "enter" for zero calibration.

If 7 presses doesn't do it, then try 10.

Hi Chuckster,
Are you aware of which charger is used for the LINC remote??

[chuckster57]

IIRC it takes the same charger that's used on older blackberry phones.