Quote:
Originally Posted by dshores
Thanks everyone. A lot of good information there. I realized I left out some information about the setup. I have two batteries on my trailer, maybe they all do not sure. The battery that is in the same compartment as the hydraulics is new, I replaced it 8-10 months ago. Both of the batteries have a battery disconnect switch which I turn and usually remove the key when it is in storage. I did not remove it this time.
Which brings up a new question: what is the purpose of the disconnect switch? Is it a factory option or aftermarket (I know I am not providing a lot of information about it, just a red T handle that has a metal piece that goes into a hole).
I'll get a picture of it and post it here.
I am considering getting a battery pack to take and run the jacks with so I can pick up the trailer and bring it home. Is there any reason NOT to do that?
I really wish I had some type of users manual for my trailer.
|
Just to confirm, the factory battery disconnect with the key, is worthless (all that I’m aware of) . They normally only disconnect about 1/2 the stuff. Smoke and co2 detectors, sometimes jacks, lights and trailer brakes stay on. Never use ours, the battery will be dead in about 10 days.
We installed a full disconnect right off the battery, 100% disconnect. Use it when the rig is not in use. Since it powers the emergency trailer brakes, it must be on while traveling.