Here is the proper way to identify which breaker needs upgrading from 5-0 to 80 amps..
First image locate the dual polarity solenoid located on the hyd pump motor..see cable circled in yellow
Next two images show both a two and a three resettable breaker setup and show you how to identify which breaker needs upgrading to 80 amp
Take a picture of your setup so,you know where the wires went and remove the old breaker ( with battery disconnected ) and install new breaker and reconnect cables
Verify hyd pump motor runs
NOTE.. the main power lead cable from battery doesn’t usually run dir3ctly to the breaker you need to upgrade. As shown in the images from m6 Alpine and a newer alpines with 3 resettable breakers
I’ve also attached link to Lipperts latest upgrade bulletin.. OF your existing cables are nice and heavy then they will do just fine with the upgraded breaker
https://lci-support-doc.s3.amazonaws...cd-0001896.pdf