2021 Bullet has Furion mount but wiring is not connected!

[Mr. Light]

Yep!

I went to install my new Vision S but when I pulled the cover off the mount the wiring was just sitting there coiled up in a bag, not connected to anything. Every installation video I can find, the wiring is already connected to a power source when the trailer is delivered. I'm guessing this is a manufacturer error? Does that mean I have to haul this thing back to the dealer and wait another couple months?

I'm handy and can do electrical on my own, just need to know the process?

Thank you
Chris

[jsb5717]

It's typically just wired to the clearance light which should be right above the mount. You should be able to pull the light and connect the wires and fish them down to the mount.

[chuckster57]

Originally Posted by Mr. Light

Yep!

I went to install my new Vision S but when I pulled the cover off the mount the wiring was just sitting there coiled up in a bag, not connected to anything. Every installation video I can find, the wiring is already connected to a power source when the trailer is delivered. I'm guessing this is a manufacturer error? Does that mean I have to haul this thing back to the dealer and wait another couple months?

I'm handy and can do electrical on my own, just need to know the process?

Thank you
Chris

You might consider yourself lucky, can’t count how many times the wires were hooked up backwards.

[Mr. Light]

I'll try that, thank you

[Crischan]

Originally Posted by Mr. Light

Yep!

I went to install my new Vision S but when I pulled the cover off the mount the wiring was just sitting there coiled up in a bag, not connected to anything. Every installation video I can find, the wiring is already connected to a power source when the trailer is delivered. I'm guessing this is a manufacturer error? Does that mean I have to haul this thing back to the dealer and wait another couple months?

I'm handy and can do electrical on my own, just need to know the process?

Thank you
Chris

Yep, same for me. I purchase a pigtail adapter for the camera that I was going to use (Rohent R9) to save time! Oh well, the mounting bracket came in handy and it was simple to wire up.

You should be able to get access to the marker lights from behind the shark fin. I was able to pull the shark fin off and tap into the marker lights. Used the rubber gasket and silicone to seal it all back up.