Made some progress with this lighting project and some not progress:
1. Salon/gallery - Installed the G4 dimmable LEDs in the 6 ceiling puck lights and the dimmer from Amazon with panel adapter from Marty Robinson. Pretty straightforward as Marty provided detailed instructions, connectors and a Youtube video for the wiring and installation. His adaptors are really for GD models so didn't quite fit requiring a bit of trimming by me. I alerted him to this and he offered a refund which I declined as I'd made it work and now he's working on modifying to fit Keystone. I will post pics and video when I figure out how to do that.
Marty is an engineer at Dow and also does 3D printing and you can get to him on Facebook Marty Robinson in Danbury TX or email
[email protected]
2. Replaced the 18W 1141 single contact bayonet bulbs in the dinette and bed reading lights with 12W 1003 bulbs that reduce brightness... temporary solution until I find an LED with low brightness.
3. Ordered LEDs to replace the 921s in the dome lights - over the sink, bathroom, and outdoor kitchen. Once again I ordered the wrong ones as they were super bright white with an industrial factory look. Marty has recommended some.