Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 

Go Back   Keystone RV Forums > Keystone Tech Forums > General RV Issues
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 07-15-2017, 08:57 AM   #1
Johnny's Journey
Senior Member
 
Join Date: Jun 2017
Location: Downey, Ca.
Posts: 344
Question "Snap Crackle Pop" with two axle's

New Summerland 202QBWE. What is the main cause for these sound and what have you or your dealer done to quit these sounds ? I do realize the axles are fighting one another when turning but the noise is excessive in my opinion. Is it lack of grease somewhere, bushing issue's if any, lack of sliders between the leaf's. Thanks ahead of time.
Johnny's Journey is offline   Reply With Quote
Old 07-15-2017, 09:52 AM   #2
bobbecky
Senior Member
 
bobbecky's Avatar
 
Join Date: Jul 2013
Location: Box Elder
Posts: 2,907
Even if you upgrade to a heavy duty greasable shackle kit, upgraded equalizer, you still have a lot of parts moving, in addition to the sounds of the electric brakes operating that you will not be able to stop. I wouldn't worry about the sounds, but an upgraded shackle kit is a big plus that will prevent a lot of wear. just sit next to a driveway in a busy park and listen to all the rigs pulling in and out, and you will hear all of them making the same sounds.
__________________
Bob & Becky
2012 3402 Montana
2012 Chevy 2500HD D/A CC
bobbecky is offline   Reply With Quote
Old 07-15-2017, 10:43 AM   #3
Ken / Claudia
Senior Member
 
Join Date: Nov 2012
Location: Fruitland
Posts: 3,357
The sounds could also be coming from the hitch system. Both areas can be noisy during hard turns. And look at those 4 tires, all those tires sticking out this way and that. You would think they are going to break the wheel or blow the tire off the rim. Yeah, that it is normal.
__________________
2013 24RKSWE (27ft TT) Cougar 1/2 ton series SOLD 10-2021
2013 Ford F350 4x4 CC 6.7 engine, 8 ft bed, 3.55 rear end, lariat package
Retired from Oregon State Police in 2011 than worked another 9.5 years as a small town traffic cop:
As of 05-2020, I am all done with 39 years total police work. No more uniforms for me.
Ken / Claudia is offline   Reply With Quote
Old 07-15-2017, 11:47 AM   #4
Johnny's Journey
Senior Member
 
Join Date: Jun 2017
Location: Downey, Ca.
Posts: 344
Quote:
Originally Posted by bobbecky View Post
Even if you upgrade to a heavy duty greasable shackle kit, upgraded equalizer, you still have a lot of parts moving, in addition to the sounds of the electric brakes operating that you will not be able to stop. I wouldn't worry about the sounds, but an upgraded shackle kit is a big plus that will prevent a lot of wear. just sit next to a driveway in a busy park and listen to all the rigs pulling in and out, and you will hear all of them making the same sounds.
Then there is an improvement that can be performed as I can tell this set-up is a bare bone's as they come for the price of this unit. I should have worded my concern's more clearly. As you mentioned above, the sounds are normal but to my ear's it's at the point that wear is more the concern than the sound it's self. All noise never can be removed 100%.

Quote:
Originally Posted by Ken / Claudia View Post
The sounds could also be coming from the hitch system. Both areas can be noisy during hard turns. And look at those 4 tires, all those tires sticking out this way and that. You would think they are going to break the wheel or blow the tire off the rim. Yeah, that it is normal.
Yes, I watched as they moved my trailer at the dealer with a forklift. It was something to see the tire's camber in opposite direction's on either side. If I could have without being ran over I would have liked to see the axle's bow while this happen's. It's all part of this configuration.
Johnny's Journey is offline   Reply With Quote
Old 07-15-2017, 12:45 PM   #5
chuckster57
Site Team
 
chuckster57's Avatar
 
Join Date: Jul 2014
Location: Modesto
Posts: 20,317
You can upgrade the shackles to "wet bolts". The plastic factory bushings are removed and brass ones are installed. Then the bolts are replaced with bolts that have grease fittings on them to lube the bushings.

The center link can be replaced with a link that has rubber bushings.
__________________

2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.

Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
chuckster57 is offline   Reply With Quote
Old 07-15-2017, 01:17 PM   #6
Johnny's Journey
Senior Member
 
Join Date: Jun 2017
Location: Downey, Ca.
Posts: 344
Quote:
Originally Posted by chuckster57 View Post
You can upgrade the shackles to "wet bolts". The plastic factory bushings are removed and brass ones are installed. Then the bolts are replaced with bolts that have grease fittings on them to lube the bushings.

The center link can be replaced with a link that has rubber bushings.
Johnny's Journey is offline   Reply With Quote
Reply

Tags
axle, rack

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by the Keystone RV Company or any of its affiliates in any way. Keystone RV® is a registered trademark of the Keystone RV Company.


All times are GMT -8. The time now is 12:02 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.