|
10-14-2013, 04:37 PM
|
#1
|
Junior Member
Join Date: Oct 2013
Location: Newburyport
Posts: 7
|
Slide out stopped working
New to RV/Trailers. I recently purchased a 2010 Bullet 248RBS. The slide out had been working, but now is stuck in the out position. I am connect to power. When attempting to close, there is no motor sound. Any suggestion on where I should start investigating the problem?
any advice would be appreciated.
Thanks!
|
|
|
10-14-2013, 05:01 PM
|
#2
|
Senior Member
Join Date: Nov 2012
Location: Fruitland
Posts: 3,357
|
I guess everything else works?. Check every breaker and fuse make sure they are good. Next I would make sure that the battery is good and has good connections. Last check if all else is good would be the motor,maybe it failed. My Artic fox had a self resetting fuse on the slide. 3 dollar part that the dealer informed me about under a sink. I spend 4 hours taking out the motor only to find it was working. At a keystone workshop the service guys said even on shorepower you need a battery in working condition and of course hooked up. Good Luck
__________________
2013 24RKSWE (27ft TT) Cougar 1/2 ton series SOLD 10-2021
2013 Ford F350 4x4 CC 6.7 engine, 8 ft bed, 3.55 rear end, lariat package
Retired from Oregon State Police in 2011 than worked another 9.5 years as a small town traffic cop:
As of 05-2020, I am all done with 39 years total police work. No more uniforms for me.
|
|
|
10-15-2013, 06:10 AM
|
#3
|
Senior Member
Join Date: Sep 2012
Location: Airdrie, Alberta
Posts: 552
|
As above, once every sude & breaker has been checked, the battery is the next culprit. Slides require a strong, charged battery to work. I have had to unhook in order to pull next to my FIL's trailer so he could close his slide, as neither his TV nor TT batteries were strong enough to power his slide back in.
If all else fails, remove the wooden trim piece over the center of your slide and you will find a chuck to manually crank the slide in using the dealer supplied, flexible shaft allen key.
__________________
2013 Passport 3220BHWE, upgrade axles, Kumho Radial 857's, all LED, TST507 TPMS, Reese DCSC, DIY corner stabilizers
2012 Ram 1500 Sport crew cab, Hemi, 4x4, 3.92 LSD, factory brake controller, S&B CAI w/scoop, Moroso air/oil can, 87mm ported/polished/knife-edged throttle body, Magnaflow exhaust, 180* t-stat, Rear lowered 2", Airlift 1000.
|
|
|
10-15-2013, 01:03 PM
|
#4
|
Member
Join Date: May 2012
Location: Hendersonville NC
Posts: 73
|
If he is hooked up to power would that not be the same connecting to a TV?
Just curious in case it happens to me some day.
|
|
|
10-15-2013, 03:56 PM
|
#5
|
Member
Join Date: Sep 2013
Location: cali
Posts: 37
|
Quote:
Originally Posted by kenm500
New to RV/Trailers. I recently purchased a 2010 Bullet 248RBS. The slide out had been working, but now is stuck in the out position. I am connect to power. When attempting to close, there is no motor sound. Any suggestion on where I should start investigating the problem?
any advice would be appreciated.
Thanks!
|
pull the fuse dont just look. happened on my new rv fuse looked good but tested with a light tester to find problem. suppose to be a light that comes on when the fuse blows but doesnt usually work
|
|
|
10-16-2013, 10:41 AM
|
#6
|
Senior Member
Join Date: Sep 2012
Location: Airdrie, Alberta
Posts: 552
|
When "power" was mentioned it didn't state what the source was, so I thought I'd throw that out there. If the fuse does turn out to be good, there is likely another fuse, like the radio. I blew the fuse on top of the radio housing itself while the fuse in the panel was fine. You 'll just have to find it.
__________________
2013 Passport 3220BHWE, upgrade axles, Kumho Radial 857's, all LED, TST507 TPMS, Reese DCSC, DIY corner stabilizers
2012 Ram 1500 Sport crew cab, Hemi, 4x4, 3.92 LSD, factory brake controller, S&B CAI w/scoop, Moroso air/oil can, 87mm ported/polished/knife-edged throttle body, Magnaflow exhaust, 180* t-stat, Rear lowered 2", Airlift 1000.
|
|
|
10-21-2013, 04:28 AM
|
#7
|
Senior Member
Join Date: Oct 2012
Location: Oakfield NY
Posts: 229
|
I have blown the maiin fuse and slides went out backwards was not till i blew 3radio fuses i figures it out Battry hooked up wrong
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|