My 3 day old outback 332RL has a forgotten stop in the pass through slider tray.
Imagine my surprise as I pulled it out and it kept on going,... right to the ground!
No broken toes, but a bit upset by such an silly over sight. I sure hope the 3 slides are anchored better than the tray to its frame.
MY SOLUTION;
I removed the tray intentionally this time. Drilled a 3/16” hole in the top of the forward side rail. Re-inserted the drawer and then installed a pin I had laying around the shop for many years. It finally came in handy. The pin Can be removed so that the tray can be taken out to allow access in the event that work needs to be performed inside the storage space.
A pretty simple fix!!
http://www.keystoneforums.com/forums...1&d=1578303112
http://www.keystoneforums.com/forums...1&d=1578303772
SLAMMER
Linear Mode
