Bed Tilt

[Keystoned]

So my 5W has the hardware and controller, Lippert/Schwintek?
But it doesn't work. It was disconnected for some reason and the PO claims no knowledge of it even being there.
So I hooked it up and the lights flash. When I hit the switch there is a click but no motion. Lights flash still, so I go into calibration mode. Same thing, click but no motion.
Any bed tilt experience here?
I'd like to fix it before installing the new mattress...

[chuckster57]

If the bed tilt is schwintec, the codes will flash the problem. One will blink 1 or 2 times indicating which motor and the other will blink up to 8 times. The codes are printed on the label. read them and post back.

[Keystoned]

Well that's the problem, they both just flash constantly, either fast or real fast, at the same time. I downloaded the manual hoping for a meaningful code but nope...

[chuckster57]

disconnect the power, wait 2 minute and try again. Both flashing means the motors are in motion.

[Keystoned]

Maybe that's why it was disconnected, could be bad motors? They are not in motion.
I have pulled power several times with the same results above...

[chuckster57]

Sending PM