You can adjust the tilt, Put the slide about 1/2 way out. Then look for the 2 long bolts that are vertical. loosen the lock nut and make sure the bolt is seated, then loosen the two bolts that hold the plates together. lower the long bolt about 1 or 2 turns and tighten everything back up.
then run the room OUT and then in. make sure the room seals both fully retracted and extended. This adjustment should bring the front edge UP and hold it there further into the rectacting.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|