|
02-08-2020, 08:14 AM
|
#1
|
Junior Member
Join Date: Mar 2019
Location: Aubrey
Posts: 27
|
Furnace ducting
I have a 2018 Hideout 258LHS. We are currently in Arizona where the evening get quite chilly and the furnace runs. I have noticed that the heated air from the furnace and out the ducts is barely moving. Should I feel air being forced out the ducts and not having to hold your hand on the duct to verify that air is moving? Is this normal or should I be able to feel the heated air blowing out with some force?
|
|
|
02-08-2020, 08:55 AM
|
#2
|
Site Team
Join Date: Mar 2011
Location: Gaylord
Posts: 26,995
|
Keystone's "test process" is to lay a sheet of toilet paper on the vent, turn on the furnace and "if the paper moves, it's working OK".... You won't find a "balanced, equalized ducting system" in most travel trailers and the further from the furnace you get, the less air flow you'll find at any duct. That's one reason why most "popular floorplans" have the furnace located near the center of the trailer, rather than on either extreme end. It's easier to get "adequate airflow to each end "from the middle" rather than push air the "entire distance from end to end"....
So, depending on your furnace location, the ducting run length, number of duct openings along that run, you may "barely move the paper" or you may "blow it 3' into the air.....
The "key" is the answer to the question: Is the room cold or does it stay relatively warm?
__________________
John
2015 F250 6.7l 4x4
2014 Cougar X Lite 27RKS
|
|
|
02-08-2020, 12:47 PM
|
#3
|
Senior Member
Join Date: Feb 2014
Location: Young America MN
Posts: 372
|
Our alpine has lots going to the bedroom (closest to furnace) and little to the other end. I partially close that bedroom vent and it forces air to the other end. If you do that make sure you don't cut off the airflow. Since you are likely to have dumps into the basement and water connection area your not likely to mess it up by just partially closing one register. All total we have 3inch in basement, a 2inch into water compartment, another 2 that just dumps into basement behind wall, a 4 in Kitchen and 2 larger (double size) registers in living room area that connect directly to the large aluminum duct under the floor.
__________________
39 foot Forest River Vengeance dragged by GMC 3500.
|
|
|
02-08-2020, 02:01 PM
|
#4
|
Junior Member
Join Date: Mar 2019
Location: Aubrey
Posts: 27
|
We have one in the kitchen, one in living area and one in the bedroom. When the furnace is running the air coming out will not move a kleenex. Is that what I should expect??
|
|
|
02-08-2020, 02:17 PM
|
#5
|
Site Team
Join Date: Mar 2011
Location: Gaylord
Posts: 26,995
|
Quote:
Originally Posted by WSCY
We have one in the kitchen, one in living area and one in the bedroom. When the furnace is running the air coming out will not move a kleenex. Is that what I should expect??
|
Does the room stay relatively warm when compared to the rest of the trailer?
__________________
John
2015 F250 6.7l 4x4
2014 Cougar X Lite 27RKS
|
|
|
02-08-2020, 02:54 PM
|
#6
|
Junior Member
Join Date: Mar 2019
Location: Aubrey
Posts: 27
|
The furnace is pretty much amid-ship. All the registers will not move a piece of kleenex. It is not the nearness to the furnace that is a factor. Based on howe it acts I would compare it to an electric oil heater that works by convection. There is no air pressure at the registers regardless where it is located.
|
|
|
02-08-2020, 02:55 PM
|
#7
|
Junior Member
Join Date: Mar 2019
Location: Aubrey
Posts: 27
|
The answer is "is htetre air being forced through the vents which reduce the run time of the furnace and thereby reducing propane usage.
|
|
|
02-08-2020, 03:22 PM
|
#8
|
Site Team
Join Date: Mar 2011
Location: Gaylord
Posts: 26,995
|
If there's no air at any duct, I'd check the plenum box attached to the furnace. You should see a couple of 3" aluminum "flex ducts" connected and going to wall vents (if you have any) and maybe a 2" flex duct headed under the floor. The bottom of the plenum is probably positioned over a cutout in the floor and connects to the "central under-floor duct" that supplies warm air to the floor vents. There may or may not be an obstruction in that duct run. You can remove a vent cover, use a mirror and flash light to inspect inside the duct. You can also use a cell phone to take photos of what's under the floor.
Essentially, don't expect "house performance" from an RV furnace duct system. Most are "multiple runs of dryer vent ducting" with unfiltered air return and a furnace "efficiency rating" of around 50%.
What I'm suggesting is that you can do some checking to see if you can find an obvious problem, but taking it to the dealer will probably be a frustrating and not profitable venture. If the trailer stays relatively warm, they're probably going to tell you, "That's the best you can get" and give it back to you, hopefully in the same condition without any "new problems or damage"...
__________________
John
2015 F250 6.7l 4x4
2014 Cougar X Lite 27RKS
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|