Dometic Furnace "Clicking"
Problem - When calling for heat the Dometic Air Conditioner clicks for about 30 seconds when the temperature reaches the set point. This is not a problem with the furnace, it runs and heats fine.
This subject has been covered often and I have read many posts about the issue. It appears that to solve the issue a dometic thermostat can be set for a differential of either 1 or 2. Two allowing the temperature differential to get rid of the annoying clicking in the air conditioning unit. My issue is I have the In-Command system so there is no visible or wall mounted thermostat to adjust.
I contacted In-Command and here is their response;
"Thank you for contacting ASA Electronics. iN•Command is not a thermostat. We simply allow the user to send a request of a temperature to the thermostat (produced by Dometic) in the ceiling. This component is their gateway and is what controls the furnace, AC, and fans. It also reports the temperature to iN•Command. It is my understanding that this tolerance cannot be adjusted through their single zone control box, but you would want to check with Dometic on this."
So my question - Where did they hide the thermostat/gateway and is it adjustable?
__________________
2019 Cougar 5th Wheel 368MBI
2018 Ram 6.4L Hemi 3500HD 4x4 w/4.10
2022 Ram 6.7L Cummins HO 3500 DRW on order
|