Pimpled wall board water damage
Need some ideas guys/gals. We ended up with a little moisture damage up in the bedroom of our fuzion 417. Noticed some pimple/bubbles in the wall paper. After some investigating, found a couple issues with the awning arm installation. The big blob of sealant at the top where the power wire comes out wasn't properly bonded. So water could get in there. Also there was no sealant put on any of the hardware holding the bracket on. The one lag screw was actually rusty, which could have been the biggest source of water infiltration. Anyways that's all fixed up now.
My question is, can these small bubbles be repaired, the adhesive is not sticky underneath, as they don't stick when you push on them.
Can one buy the wall paper material and effectively "re wallpaper" that panel?
And lastly, if need be, how hard is it seperate the interior panel from the white styrofoam exterior insulation. As it fully bonded to the entire panel.
Although this is most definitely caused by poor manufacturing process, I don't expect much help from dealer/Keystone. I am fully capable of doing the work myself it the products are available.
|