Xantrex 2000W inverter
Trying to figure out a few settings given a pair of Dragonfly 100Ah batteries. Dragonfly low voltage disconnect seems to be 10.5, and that's the same as the low batt cut off listed for the Xantrex default. The inverter lbco recovery is default set to 13.1 but is allowed to be set a lbco voltage + 0.2 volts. Should I set it at 10.7?
Also, it is set to auto off at 25 hours given continuous very low power loads. I think that function should be turned off? Especially for shore power use?
Finally, if on shore power, is there any reason not to leave it on 24/7 while we're in and out a few times a week?
|