|
Just fully completed installation of my EMS-HW30C. Pix are attached.
The EMS was installed in the space adjacent to where the shore power entered the trailer - the junction box is visible in the photo (along with sawdust left behind by Keystone!); it is an otherwise mostly empty area where I found a Studor vent from the tub/shower. I mounted the EMS unit on rubber washers (circular items at the corners of the box) to minimize the floor from being used as a sounding board due to unit hum.
The remote display was mounted on the side of the cabinet that houses the power cable/stereo. I wish the remote display had a jack on the back as well as the underside. This way one could possibly hide the hole for the data cable.
It'll be fun watching the load. It certainly will make appliance use management much easier.
__________________
Now: 2019 Winnebago 2500FL w/e2 WDH;Sold: 2015 Bullet Premier 19FBPR (shown)
2012 Ford F-250 Lariat Super Duty Crew Cab (gas 6.2 L, 3.73 gear ratio 2WD, 172" WB)
|
Threaded Mode
