Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 

Go Back   Keystone RV Forums > Keystone Tech Forums > Repairs & Maintenance
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 05-07-2016, 05:49 PM   #1
chris199
Senior Member
 
Join Date: Aug 2011
Location: PA
Posts: 620
2015 3791RD Dual 6v Battery Upgrade-Parts&Process

Got tired of not having enough juice and upgraded from a single 12v to 2 6v Trojan T145's. Took some pics along the way. Here are the components, supplies and process we took. (32 yo son was a tremendous help in planning! Was his idea to remove poles from old lid and install in new lid.)

Components/Supplies:
2 Trojan T145 6v Batteries

Dual Battery Box: NOCO HM426 Dual 6-Volt Commercial Grade Battery Box for Automotive, Marine and RV Batteries http://amzn.com/B003VAUG5A

Hole Saws: 2 3/4 (for bottom vent) and 1 1/4 for poles and top vent

Bottom Vent: Valterra A10-3305 Battery Box Cone Vent http://amzn.com/B00HSO4IQI

Top Vent (PVC Elbow): LASCO 1-in Dia 90-Degree PVC Sch 40 Elbow http://www.lowes.com/pd_22706-1815-4...+dia+sch+elbow

5/16 Hex Nut to Secure Top Vent: Gampak 2-Pack 1-in Rigid Lock Nuts http://www.lowes.com/pd_75464-15527-...ductId=1100181

Battery Cable to connect batteries in series (Positive of Battery 2 to Neg of Battery 1) 4 Gauge 18in - 5/16 in Hole Sizes Red Solar Battery Cables Power AWG Solar Inverter Golf Cart Car GLUE SEALED http://amzn.com/B01154Q18E

Weather Stripping (Marine Use) Frost King 0.75-in x 10-ft White Vinyl Foam Window Weatherstrip http://www.lowes.com/pd_96113-1410-R...99b6ef3cc#noop

Great Stuff Sealant to fill cable holes in box..near lid. Dow GREAT STUFF Window and Door 12-fl oz Spray Foam Insulation http://www.lowes.com/pd_15634-236-23...pl=1&Ntt=15634

Loctite 2-in-1 Seal and Bond: LOCTITE 2-in-1 White Paintable Latex Window and Door Caulk http://www.lowes.com/pd_85671-69-209...t=loctite+2-in

Poles in New Lid were removed from old box lid.

Existing hose and hose clamp used.

Process:
Old Box:


Loosen hose clap and disconnect vent hose from old box.

Remove Cables from Old Lid Poles
Remove Old Box Lid, old battery and Base. Before removing base, you'll need to remove the 2 self tapping screws holding box to floor. Save self tapping screws used to screw old box to floor of RV.

Remove pos and neg poles from old lid.



Review location of vent hole in floor to new box.
Review location of poles to be installed in new lid. Note: these need to fit in the center, in effect, between the two batteries' caps when batteries in new box.
Review location of new vent hold...where pvc elbow will be installed.

Drill a 2 3/4 hole in bottom of new box in prep for vent installation. Note we had to router off about 1/8" of vent flange to have it fit in hole near edge of box. Used Loctite seal and bond around base of flange. Base of flange really snaps into the 2 3/4" hole. Fits well.

Can now position box back in RV, placing vent through the bottom of box into the original vent hole in floor of Monty. make sure box is square in Monty.....use Self tapping screws from original box and drive through the new box and into floor of Monty. We installed screws in 2 opposite corners of box where the base of the box was touching the floor of Monty.

Box is in Monty.

Put one battery in box. Slide to one side. In out case, pos pole was at 1 o'clock and neg was at 7 o'clock. Put in 2nd battery. We added a handle to one battery for when one needs to be removed down the road.

Connect batteries in series. Using new red battery cable, connect the pos pole of battery on left to neg pole of battery on right.

Take lid. Determine best location of pos and neg poles in lid being sure to check that pole sticking through bottom of lid wont hit the batteries below. Best place for us was in the center area of lid....just above where the two batteries met...appox 7 3/4" from each edge of lid.

Drill two 1 1/4 holes for the poles. Install poles in new lid.



Locate best place for pvc elbow...lid vent. We put it in corner nearest to existing vent hose. Drill 1 1/4" hole for pvc elbow. Pvc elbow actually fit the hole perfectly. We really threaded the elbow right into the hole. Put the hex ring on inside of lid on the threaded pvc elbow. Added seal and bond to threads of pvc elbow to be sure ring stays attached.

Apply weather stripping to top of box. Cut off weather stripping where brass lid nuts would screw to box.

Using a piece of cardboard to prevent Great Stuff from dripping in box...form an inner wall by one of the boxes' cable slots and fill with Great Stuff. Be sure all cavities of battery box are filled.

Lid is ready.

Using cables from old battery, connect battery poles to poles in lid. Pos to Pos and Neg to Neg.

Connect the original 2 Monty black (pos) cables to red/pos terminal of lid.

Connect the original 2 Monty white (neg) cables to the black/neg terminal of lid.

Using Nuts that came with the new box and lid, secure new lid to new box.

DONE!



See Library of Pics...http://s292.photobucket.com/user/cdr...tery%20Project
__________________
Chris and Patty

2015 Keystone Montana 3791RD Legacy Edition, MorRyde 4000, Dual pane windows, Goodyear G rated tires.

2013 GMC Sierra 3500HD, Duramax, SLE, SRW, Crew, Hensley Trailer Saver hitch, Blue Ox BedSaver.
chris199 is offline   Reply With Quote
Old 05-08-2016, 08:25 AM   #2
Milocka
Member
 
Milocka's Avatar
 
Join Date: Feb 2016
Location: Denver, CO
Posts: 57
Awesome post! I just ordered the NOCO case. I might just have to copy you and do the posts on the lid too, very clean install!
Milocka is offline   Reply With Quote
Old 05-08-2016, 10:13 AM   #3
Desert185
Senior Member
 
Desert185's Avatar
 
Join Date: Jul 2014
Location: Nevada
Posts: 2,695
Looks to be well thought and engineered.

My current battery located in the forward landing gear compartment is vented to the general space, which is well vented to the outside. What issues would there be to do the same when I convert to two GC batteries?
__________________
Desert185 🇺🇸 (Retired Chemtrail vendor)
-Ram 2500 QC, LB, 4x4, Cummins HO/exhaust brake, 6-speed stick.
-Andersen Ultimate 24K 5er Hitch.
-2014 Cougar 326SRX, Maxxis tires w/TPMS, wet bolts, two 6v batts.
-Four Wheel 8' Popup Camper.
Desert185 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by the Keystone RV Company or any of its affiliates in any way. Keystone RV® is a registered trademark of the Keystone RV Company.


All times are GMT -8. The time now is 11:32 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.