Morryde CRE 3000

[scuba0331]

Hello, I am wanting to install a Morryde CRE/3000 on my 2008 Keystone Outback 26RLS. Based on the qualification form from Morryde I have an Under Slung axle with exactly 3.25" from the frame to the center of the bolt hole in the frame hanger. Based on the form I have to have 4.25" from the frame to the center of the hanger.

Would flipping my axle to make it an Over Slung the only way I could use the Morryde?

Thank you!

[bobbecky]

I think, from what I've seen on our rig, that they are concerned with the distance below the frame where the springs are attached. The Morryde unit is pretty long vertically, and to keep the springs somewhat level after installation, they need that distance at the ends of the springs. You may need longer frame hanger brackets on the ends to make it work. I wouldn't change the position of the axles on the springs.

[scuba0331]

Thank you for the reply!