326RDS users help

[louielouieohoh]

I'm looking for an owner to complete a simple measurement for me.

If you own a 326RDS and have a newer model than 2017 (2018, 19, 20, 21) and ... you have a "wide" storage door on the rear of the passenger side. I'd love to know the dimensions of the door (overall width and height including the trim around the door).

I have a 2017 ... with 4 smaller compartment doors ... the later models I've seen have 3 doors, one wide and 2 smaller sized.

[louielouieohoh]

Picture of my doors attached.

[louielouieohoh]

I have since found a picture of the wide door ... and its on both sides! I need the overall measurement of the larger storage door.

[louielouieohoh]

Any 326RDS owners out there?

[chuckster57]

Are you wanting to change out your doors?

[flybouy]

I'm guessing those doors are framed out at the factory. Enlarging the door may not be a simple swap out.

[louielouieohoh]

Yes, the doors are factory. I'm wanting to replace two of the factory doors with a single door, the same width as the two doors. I looked today and the two doors are separated by a post. I sent a picture of said post to Pan Pacific to see if it can be safely removed. The frame and doors are under the slide.

The 2 doors being replaced are 30x16. The post is 2" square aluminum tubing. I will be looking to get a 62x16 door. They are contacting Ketstone to determine if the post can be safely removed without damaging structural integrity of the wall.

Crossing my fingers.