See Level tank monitoring system

[SargeW]

I am considering adding a See Level system to the new TT to replace the factory in tank sensors. I have installed it 4 times before on various other RV's, so the install is not an issue. The question is has anyone dropped the coroplast recently and seen the depth of the holding tanks, and the accessibility of the the sensor wiring?

Do the tanks have a seam in the middle edge of the tank, or are they one piece tanks?

I would like to get this info from Keystone, but they don't like to share. And getting a return call from the dealer is dicey at best. Though I would check here first.

[chuckster57]

Your tanks are not real deep like your bus was, but there should be enough depth to trim the strip and put them on. There isnt a seam on the sides and the sensors are usually on the drain side of the tanks.

I would think the install would be about a 3 on a scale of 1 to 10, just time consuming.

[bobbecky]

This link shows what your tanks look like. https://www.trekwood.com/parts-searc...tegory=&page=3

[SargeW]

Great link Bob, thanks! That is easily within the See Level sensor strip length. With the existing sensors on the dump valve side, that would simplify the wiring runs. This may get traction after all!