InCommand

[lonerider98]

My 2022 only shows the fresh water level. the other 4 tanks show empty is this a easy fix or a return to dealer? This is the global connect model. any suggestions? Thanks

[ChuckS]

Some of your original post appears to have not posted... It looks like you are having issues with the holding tank readings shown on the display on the In Command... If this is the case and none are reading correctly then try the following:
1. Reset the BCM and power the display up and check tank levels
2. If tank levels on all tanks still not reading then
.. there is a ribbon cable to the BCM for the tank sending units... verify good connections

Before I would take to the dealership for this on Monday give Jensen In Command Tech Support a call and they may be able to help you as well

https://in-command.net/control-systems/

[ChuckS]

With the BCM powered off - power button is on the BCM to turn off gently remove the ribbon cable as detailed in this image (A) and reconnect and then power the BCM and display back up to see if the holding tanks now display correctly

Link to TS guide for your version of In Command

https://in-command.net/wp-content/up...ng%20Guide.pdf

[Ram Nation]

Originally Posted by lonerider98

My 2022 only shows the fresh water level. the other 4 tanks show empty is this a easy fix or a return to dealer? This is the global connect model. any suggestions? Thanks

Probably like my Incommand readings for my holding tanks. Never been right since day one. Kinda like the Key TV also.

[ChuckS]

Originally Posted by Ram Nation

Probably like my Incommand readings for my holding tanks. Never been right since day one. Kinda like the Key TV also.

If the proper resistance values are loaded into the floorplan for those tank sending units .. each sending unit resistance value will be different then the display seen should be in the ball park...

Of course tank sending units arent the greatest anyway... but if the values loaded are not correct the tank readings will never be right