Sorry to hear about the tank leak. It is likely the inlet fitting on the tank of it doesn't leak until full. I was afraid of that on my new Sydney so I over filled the tanks during the pdi to ensure there were no leaks. I was lucky.
I have read about this issue more than once. I hope all is resolved to your satisfaction. Make sure they replace all water impacted insulation.
My shower floor appears to be firm. This is another common problem caused by inadequate bracing beneath the shower assembly. I had that problem in a previous coach that was repaired under warranty. They will likely have to remove the assembly to beef up the bracing. This isn't a bad thing because then the shower drain plumbing will all be exposed as it could be leaking as well.
Good luck
|